Epson EH-TW6000 User Manual

Troubleshooting
73
Image colors are not right
Check Remedy
Is the image signal format setting correct? When Video is input
If nothing is projected even when Video Signal is set to Auto
from the configuration menu, set the signal that matches the
connected device.
s Extended - Input Signal - Video Sig-
nal p.63
When Component is input
If nothing is projected even when Component is set to Auto
from the configuration menu, set the signal that matches the
connected device.
s Extended - Input Signal - Compo-
nent p.63
Are the cables connected correctly?Check that all the cables required for projection are securely
connected.
s p.18
For the Video and Component ports, make sure the connector is
the same color as the cable port.
s p.18
Is the contrast adjusted correctly?
Adjust the Contrast setting from the configuration menu.
s Image - Contrast p.57
Is the color adjusted correctly?
Adjust the Advanced setting from the configuration menu.
s Image - Advanced p.57
(Only when projecting images from a video
device)
Are the color saturation and tint adjusted cor-
rectly?
Adjust the Color Saturation and Tint settings from the config-
uration menu.
s p.57
Images appear dark
Check Remedy
Is the image brightness set correctly?
Adjust the Brightness setting from the configuration menu.
s Image - Brightness p.57
Is the contrast adjusted correctly?
Adjust the Contrast setting from the configuration menu.
s Image - Contrast p.57
Is it time to replace the lamp? When the lamp is nearly ready for replacement, the images be-
come darker and the color quality becomes poorer. When this
happens, replace the lamp with a new lamp.
s p.81
Projection stops automatically
Check Remedy
Is Sleep Mode enabled?
If no image signal is being input and no operations are made for
approximately 30 minutes, the lamp turns off automatically, and
the projector enters standby status. The projector returns from
standby status when you press the
button on the remote
control or the
button on the control panel. If you do not want
to use Sleep Mode, change the setting to Off.
s Extended -
Operation - Sleep Mode p.63

Epson EH-TW6000 Specifications

General

Matrix size	0.61 \
Projection distance	2.95 - 4.8 m
Projection technology	LCD
Contrast ratio (typical)	-
Screen size compatibility	- \
Projector native resolution	1080p (1920x1080)
Keystone correction, horizontal	± 30 °
Aspect ratio	16:9
RS-232 ports	1
Connectivity technology	Wired
Focal length range	18.2 - 29.2 mm
Aperture range (F-F)	1.51 - 1.99
Lamp type	UHE
Lamp power	230 W
Light source type	Lamp
Service life of light source	5000 h
DVI port	No
AC (power) in	Yes
USB connector type	USB Type-A
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
S-Video inputs quantity	0
Supported video modes	1080p
Supported graphics resolutions	1920 x 1080 (HD 1080)
RMS rated power	20 W
Product color	Black
Market positioning	Home cinema
Power source	AC
AC input voltage	100 - 240 V
Voltage tolerance	10 %
AC input frequency	50 - 60 Hz
Power consumption (standby)	- W
Power consumption (typical)	274 W
Noise level	- dB
Noise level (economic mode)	24 dB

Weight and Dimensions

Weight	6000 g