EH-TW8000/TW9000/TW9000W Troubleshooting CONFIDENTIAL
SEIKO EPSON 36 Revision A
Lamp Error
LE Lamp burnt out
1. Check the following one by one. After checking and improving,
turn on the power again and check if the same error occurs again.
Lamp Cover status
Secure it if it is loose/open.
Lamp attachment
Check the lamp and secure it if it is loose.
Lamp status (whether the lamp is broken/damaged.) Take out and
check the lamp for damage.
• If the lamp is not cracked: Re-fit the lamp and turn on the
power. If the error continues, replace the lamp with a new
one.
• If the lamp is broken/damaged, replace it with a new one.
Air Filter's condition (dirt accumulation, clogging)
When clogging or the like is found, clean or replace the filter.
When using the projector at an altitude of 1500 m or more, set
"High Altitude Mode" to "On".
2. If the same error occurs after turning the power on, connect the
PC to the projector and check the error code on the AS Menu,
then carry out the remedy referring to the reference No.2 on the
right column.
1. "3.3.1 Air Filter (p64)"
"3.3.2 Lamp (p64)"
2. " Troubleshooting from the
Error Code on Lamp Errors
(p38)"
LF Lamp failure
LC Lamp Cover Open Error
LED Status Corresponding error code and error name Remedy Reference
Red
Power
To Next Page
Loading...
Need help?
General
