Epson ELPLP29 - Rear

6
Before Using the Projector > Part Names and Functions
Rear
• Computer/Component Video
ports P.13, P.18
Inputs analogue video signals from
a computer and Component Video
g
signals from other video sources.
• Monitor Out port s P.1 4
Outputs the projected analogue
computer signal to an external
monitor. This feature is not available
for video signals.
• remote control infrared
receiver s P. 9
Receives signals from the remote
control.
• power inlet s P.2 0
Connects the power cable.
• Video port s P.18
Inputs Composite Videog signals to
the projector.
Connect using an A/V cable.
• S-Video port s P.1 8
Inputs S-Videog signals to the
projector.
Connect using an S-Video cable.
• security lock s P.6 4
• Audio port s P.1 4, P.1 9
Inputs audio signals to the projector.
Connect using an A/V cable, or a stereo
RCA cable.
When using computer and video
equipment alternately, swap the cable or
use an audio switch.
• Control (RS-232C) port s P.66
Connects the projector to a computer using
an RS-232C cable. This port is for control
use and should not be used by the customer.
• remote control holder s P. 9
Store the remote control in here
when not in use.