29
Turning On the Power and Projecting Images
Procedure
1
Check that the Power indicator has
stopped flashing and is lit orange.
2
Turn on the power for all equipment connected to the projector.
For a video source, press the [Play] button at the video source to start
playback if necessary.
3
Press the [Power] button on either
the projector's control panel or the
remote control to turn on the power
for the projector.
The Power indicator flashes green, and
after a short period it stops flashing and
projection starts.
Wait until the Power indicator lights green
(it normally takes about 40 seconds to
change).
Tip :
The projector's control panel and remote control buttons cannot be operated while the
Power indicator is flashing green.
Depending on the settings, the message "No-Signal." may appear. See "Setting" - "No-
Signal Msg." (p.51)
Power
Lit orange
S-Video/VideoComputer
Menu
A/V Mute
E-Zoom
Freeze
Color Mode
Power
ESCAuto
Enter
Power
Remote control
Changes from flashing to lit green
Turning On the Projector
To Next Page
Loading...
