10 1 • Installation
6.
Disconnect the computer’s mouse cable from the mouse port on the
back of the computer and connect the mouse connector of the PS/2
mouse cable (6-pin) to the mouse port on the back of your laptop.
• If your system uses a serial mouse, perform steps 6 and 7
using the serial mouse cable instead of the PS/2 mouse cable.
7. If you are planning to use the ELP Link II software, connect
either end of a PC serial cable to the PC SERIAL terminal on the
large end of the main cable.
8. Connect the other end of the PC serial cable to the serial port on
the back of your laptop.
9. Tighten all connector screws to ensure secure connections.
• Note that you will not be able to use the ELP Link II software
if your system does not have two serial ports.
Computer In 1 Computer In 2
Monitor
Audio In 1 Audio In 2 Audio Out
S-Video
Video In
Audio In
L
R
Remote
1-Mouse/ Com-2
PC serial
cable
PS/2 mouse
cable
PS/2 mouse
cable
Serial mouse
cable
Monitor cable
Audio cable
Main cable
Monitor port
Mouse port
Com port
Audio port
Serial port
To Next Page
Loading...
