89
Maintenance
The air filter can be replaced even if the projector is installed to a ceiling.
PROCEDURE
Turn the projector power off, wait for the cool-down
period to end, then disconnect the power cable.
The cool-down period lasts for about 20 seconds.
Put your finger into the recess in the knob of the air
filter cover, and lift up the air filter cover to remove it.
Replace the air filter with a new one.
Remove the old air filter, and install the new air filter. Place the
new air filter so that it does not slip into the air intake vent.
Install the air filter cover.
First insert the tabs, then press down on the opposite side until it
clicks into place.
Replacing the Air Filter
1
2
Knob
3
4
Tabs
TIP
Dispose of used air filters properly in accordance with your local
regulations.
To Next Page
Loading...
Need help?
General
