90
Saving a User's Logo
You can record the image that is currently being projected as a user's logo.
PROCEDURE
Project the image that you would like to use as a
user's logo, and then press the [Menu] button.
Select the "User’s Logo" menu, and then press the
[Enter] button.
Select "Yes" in the sub-menu, then press the [Enter]
button.
TIP
When a user's logo is recorded, the previous user's logo will be
erased.
1
Remote Control
2
TIP
•If the "User’s Logo Protect" function of "Password Protect" is set to
"ON", a message is displayed and the user's logo can not be
recorded. To record a user's logo, set "User’s Logo Protect" to
"OFF" first. p.29
•If keystone correction or E-Zoom have been carried out, they will be
cancelled when the "User’s Logo" menu is selected.
3
TIP
When you press the [Enter] button, the images will be displayed at the
original image signal resolution, so that if you are projecting images
that have a resolution that is different from the number of pixels on
the projector's panel, and if you are projecting video images, the
display size will change.
To Next Page
Loading...
Need help?
General
