67
Using the Configuration Menu Functions
Select a sub-menu item.
Tilt the [ ] button on the remote control up and down or press
the [ ] and [ ] buttons on the projector's control panel to
move to the sub-item to be set, and then press the [Enter]
button.
The items that are displayed in the "Image" menu, "Signal"
menu and "Info" menu vary depending on the input source that
is being projected.
Change the setting.
•Tilt the [ ] button on the remote control or press the [ ],
[ ], [ ] and [ ] buttons on the projector's control panel to
change the setting.
: Current setting value
: Currently-selected setting item
•If you press the [Enter] button when at items with a
displayed, the setting screen for that item will be displayed.
After making the setting, press the [Enter] button to accept the
setting. The will change to green.
Close the menu.
Press the [Menu] button.
Refer to "List of Functions" for details on the functions of each menu
item. sp.51
To Next Page
Loading...
