59
EMP-S1 User’s GuideAppendices > Projector Care
f Replacing the air filter
Replacing the air filter can also be performed when the projector is
mounted to a ceiling.
A
Turn off the projector power, wait for the cool-down
period to end, then disconnect the power cable.
Cool-down takes about 20 seconds.
B
Put your finger into the recess in the air filter hook,
and lift up the air filter to remove it.
C
Replace the air filter with a new one.
Take out the old air filter and install the new one. Please ensure there
are no gaps between the air filter and the plastic grill.
D
Replace the air filter cover.
First insert the tabs, and then press down on the opposite side until it
clicks into place.
p
Dispose of used air filters properly in accordance with your
local regulations.
To Next Page
Loading...
Need help?
General
