22
Turning on and Projecting
• When using the “Direct Power
ON” feature, the power turns
on when the power cable is
connected.
• When using above an altitude of
about 1500 m, make sure you
set the “High Altitude Mode” to
“On”.
User’s Guide “Extended
Menu”
Control Panel
Remote Control
Lit Flashing
Orange Standby
Press
to start projecting.
* In this mode, you can unplug the
power cable.
Green Warming up
Wait for a short time (about 30
seconds).
In this mode pressing
has no effect.
Green Projecting
Reading the Indicators
(Accessory
Power Cable)
Slide the A/V mute slide to open it.
Connect the power cable.
Turn on the
power supply for
the connected
equipment.
Turn on the power.
• No Image is Projected p.23
• Adjusting Focus p.24
• Correcting Keystone Distortion
p.24
Do not look directly
into the lens.
To Next Page
Loading...
