23
English
No Image is Projected
For Notebooks and Computers with Liquid Crystal Displays
Change the computers output source. Hold
down the
key and press the appropriate
key (the one usually labelled / ).
After changing the setting, wait a few
seconds for projection to start.
Computer’s “User’s Guide”
Depending on the computer, each time the
key for changing the output is pressed, the
state changes as follows.
Examples
NEC
Panasonic
SOTEC
HP
TOSHIBA
IBM
SONY
DELL
FUJITSU
Macintosh
Use mirroring or display detection.
Depending on the OS, it is possible to
change by pressing the
key.
When “Computer” is displayed at the
bottom left of the screen
When “Video” is displayed at
the bottom left of the screen
You can switch the input source
to computer by doing one of the
following.
Press
on the control panel
Press
on the remote control
If it still does not project
For Video Equipment
Start playback then press .
Computer only Screen only Both
To Next Page
Loading...
