24
Adjusting Position and Focus
(Setting up for the fi rst time or after moving)
* When moving the projector, make sure the front foot is retracted.
Raising the Projection Position (Adjusting the front foot)
Push up the foot adjust lever.
Correcting Keystone Distortion
If the projector is tilted the image distorts in the
shape of a keystone, you can correct this by doing
the following.
You can adjust the vertical tilt to a maximum of about
30°(20° when projecting a component video image
with a ratio of 16:9).
The greater the angle of tilt, the harder the image is
to focus. Setup the projector at a lower angle of tilt.
Normal
Wide Top
Wide Base
Extend Retract
Rear Adjustable
Foot
• You can also make keystone
corrections from the
confi guration menu.
User’s Guide “Settings Menu”
• Hold down and press
for more than one second to
reset the correction value to the
default setting.
• Adjust the horizontal tilt by
turning the left rear foot.
If keystone correction or zoom adjustment are performed, the “Image Shift” adjustment screen is
displayed. If you do not want to fi ne tune the projection position, press the
.
Rear Adjustable Foot
Adjusting Projection Size
Enlarge Reduce
Adjusting Focus
To Next Page
Loading...
