Replacing Consumables
53
f How to replace the lamp
A
After you turn off the projector's power and the
confirmation buzzer beeps twice, disconnect the
power cable.
B
Wait until the lamp has cooled down, then remove
the lamp cover.
Loosen the lamp cover fixing screw with the screwdriver supplied
with the new lamp or a + head screwdriver. Then slide the lamp
cover straight forward and lift it to remove.
Warning
• When replacing the lamp because it has stopped illuminating,
there is a possibility that the lamp may be broken.
If replacing the lamp of a projector which has been installed on
the ceiling, you should always assume that the lamp is broken,
and you should stand to the side of the lamp cover, not underneath
it. Remove the lamp cover gently. Small pieces of glass may fall
out when the lamp cover is opened. If pieces of glass get into your
eyes or mouth, seek medical advice immediately.
Caution
• When replacing the lamp because it has stopped illuminating,
there is a possibility that the lamp may be broken.
Wait until the lamp has cooled down sufficiently before removing
the lamp cover. If the lamp is still hot, burns or other injuries may
result. It takes about one hour after the power has been turned off
for the lamp to be cool enough.
Procedure
To Next Page
Loading...
Need help?
General
