57
Saving a User's Logo
You can save the image that is currently being projected as a user's
logo.
Depending on the area of purchase, the User's Logo function may not
be available for EMP-X5/S5. In that case, the user's logo cannot be
saved.
A
Project the image you want to use as the user's
logo, and then press the [Menu] button.
B
In the configuration menu, select "Extended"-
"User's Logo".
s "Using the Configuration Menu" p.23
Check the buttons you can use and the operations they perform in
the guide under the menu.
C
When "Choose this image as the User's Logo?" is
displayed, select "Yes".
q
When a user's logo is saved, the previous user's logo is
erased.
Procedure
Using the remote control Using the control panel
q
• If "User's Logo Protect" from "Password Protect" is set
to "On", a message is displayed and the user's logo
cannot be changed. You can make changes after setting
"User's Logo Protect" to "Off".
s
p.19
• If "User's Logo" is selected when Keystone, E-Zoom,
Aspect, or Progressive are being performed, the function
currently being performed is cancelled.
q
When you press the [Enter] button on the remote control or
the control panel, the screen size may change as it changes
to the resolution of the image signal.
To Next Page
Loading...
Need help?
General
