To enter a new value, select N. You see the following prompt:
Enter new skewed sectors per head
in format (O-16):
Enter the recommended number, which equals the maximum
sector number for the drive minus 1. The maximum sector
number depends on the drive type. Then press (Enter].
4.
The program now allows you to edit the defective track table.
At the bottom of the table is this prompt:
Modify defective track table ? (Y/N)
Select N if you want to leave the table as it is. Then skip the
next section and go to “Formatting the Disk” on page 5-8.
To add bad tracks to the defective track table, see the next
section.
Modifying the Defecfive Track Table
If you select
Y
to modify the table, you see the following
options at the bottom of the table:
Defective Track Table : Move box cursor to
desired track with cursor key
A = Add track, C
= Change track,
D=
Delete track, F
= Finish editing
Enter command :
5-6
Formatting a Hard Disk
To Next Page
Loading...
