Epson Endeavor - Using a Password

Using a Password
If you set a System Access password when you ran the SETUP
program, you must enter it every time you turn on or reset the
computer. Follow these steps to use your password:
1.
If you do not have a hard disk, insert your system diskette
in drive A.
2.
Turn on or reset the computer. You see the following prompt:
Enter Password:
3.
Type your password. You see an asterisk for each character
you type. Then press [Enter].
After you type the password correctly and press [=I, the
computer loads the operating system and displays the
command prompt.
Note
If you do not know the correct password, see “Password
Problems” in Chapter 6.
Changing or Deleting a Password
To change or delete your password, you must run the SETUP
program and follow the instructions for entering a password in
Chapter 2 of the Setup Guide.
If you do not know your password, see “Password Problems”
in Chapter 6.
Using Your Computer
1-23