Your computer may have a hard disk drive already installed in
the vertical drive bay. If not, you can install one hard disk drive
in this bay.
It is best to install your computer’s first hard disk drive in the
vertical drive bay. If you add a second hard disk drive or
diskette drive, use the lower horizontal drive bay.
How to Use This Chapter
To install or remove a drive, first remove the computer’s cover
as described on page 2-4. Then see the table below for a guide
to the instructions you should follow next in this chapter.
After you install or remove your drive(s), replace the
computer’s cover as described on page 2-29. Then see
“Post-installation Procedures” on page 3-36 for additional steps
you may need to perform.
Installing and Removing Drives
3-3
To Next Page
Loading...
