Name: Epson ET-2810 Series
Brand: Epson
Rating: 4 (1 reviews)

To Next Page

To Previous Page

There is dust or dirt on the originals or the scanner glass.

Solutions

Remove any dust or dirt that adheres to the originals, and clean the scanner glass.

& “Cleaning the Scanner Glass” on page 76

The original was pressed with too much force.

Solutions

If you press with too much force, blurring, smudges, and spots may occur.

Do not press with too much force on the original or the document cover.

& “Placing Originals on the Scanner Glass” on page 31

Oset Appears in the Background of Scanned Images

When scanning thin originals, images on the back may be scanned at the same time.

Solutions

When scanning from the scanner glass, place black paper or a desk pad over the original.

& “Placing Originals on the Scanner Glass” on page 31

Cannot Scan the Correct Area on the Scanner Glass

The originals are not placed correctly.

Solutions

❏ Make sure the original is placed correctly against the alignment marks.

❏ If the edge of the scanned image is missing, move the original slightly away from the edge of the

scanner glass. You cannot scan the area within approximately 1.5 mm (0.06 in.) from the edge of the

scanner glass.

& “Placing Originals on the Scanner Glass” on page 31

Solving Problems

Printing, Copying, and Scanning Quality is Poor

Scanned Image Problems

143

Questions and Answers:

Need help?

Do you have a question about the Epson ET-2810 Series and is the answer not in the manual?

Epson ET-2810 Series Specifications

General