Single Sheets with the Paper Guide (1/1)
EPSON FX-880+/FX-1180+ Quick Guide
Single Sheets with the Paper Guide
Note:
It is recommended that you close the flap on the
front cover if paper is not loaded from the front
slot.
Follow these steps to load paper in the paper
guide:
1. Make sure the paper guide is in the
upright position. Then set the
paper-thickness lever (located under the
printer cover) to 0 if you are using
ordinary single-sheet paper. (If you are
using envelopes, see “Special Papers”
for instructions on setting the
paper-thickness lever.) Also move the
paper release lever to the single-sheet
position.
2. Turn on the printer, if necessary.
3. Slide the left edge guide until it locks in
place next to the triangle mark on the
paper guide. Next adjust the right edge
guide to match the width of your paper.
4. Insert a sheet of paper with the printable
side down between the edge guides until
it meets resistance. The printer feeds the
paper automatically and is ready to
print.
If the first printed line on your page
appears too high or low, you can use the
Micro Adjust function to adjust the
top-of-form position. See “Micro Adjust
Function” for more information.
-1
0
1
2
3
4
5
6
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
Need help?
General