Special Papers (2/3)
EPSON FX-880+/FX-1180+ Quick Guide
c
Caution:
❏ It is best to load continuous paper
with labels on the pull tractor.
Loading labels on the rear or the front
push tractor is not recommended.
❏ Never feed labels backward using the
Load/Eject or Tear Off/Bin
button. When fed backward, labels
can easily peel off the backing sheet
and cause a paper jam.
❏ Because labels are sensitive to
temperature and humidity, use them
only under normal operating
conditions described below:
❏ Do not leave labels loaded in the
printer between jobs; they may curl
around the platen and jam when you
resume printing.
❏ Do not load continuous paper with
labels from the rear paper slot.
Because the paper path from the rear
slot is curved, labels may come off
their backing sheets inside the printer
and cause a paper jam.
❏ Do not load paper that is curled or has
been folded.
Removing continuous paper with labels
To avoid peeling labels off the backing sheet
and jamming the printer, follow these steps
to remove continuous paper with labels
from the printer:
1. Tear off the fresh supply of continuous
labels at the perforation nearest the
paper entry slot.
* perforation nearest the paper entry slot
2. Hold down the LF/FF button to eject the
remaining labels from the printer.
c
Caution:
Never feed labels backward using the
Load/Eject or Tear Off/Bin button.
When fed backward, labels can easily
come off the backing sheet and cause a
paper jam.
Temperature
Humidity
15 to 25°C (59 to 77°F)
30 to 60% RH
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
Need help?
General