Paper-Type Switching (1/2)
EPSON FX-880+/FX-1180+ Quick Guide
Paper-Type Switching
You can easily switch back and forth
between printing on continuous paper with
a push tractor and printing on single sheets
without having to remove or reload the
continuous paper.
Switching to printing on single
sheets
Follow the steps below to switch from
printing on continuous paper from a push
tractor to printing on single sheets.
Note:
❏ If continuous labels are loaded in the printer,
remove them before switching to single-sheet
printing. See “Special Papers” for more
information.
❏ If the tractor is in the pull position, remove
any continuous paper from it before
switching to single-sheet printing. See
“Continuous Paper with the Pull Tractor”
for more information.
1. If any printed pages remain in the
printer, press the Tear Off/Bin button to
advance the paper to the tear-off
position. Then tear off the printed pages.
c
Caution:
Make sure you tear off your printed
document before you press the
Load/Eject button in the next step.
Reverse feeding several pages at a
time may cause a paper jam.
2. Press the Load/Eject button to feed the
continuous paper backward to the
standby position. The paper is still
attached to the push tractor but is no
longer in the paper path.
3. Lower the continuous paper support on
the paper guide until it clicks into place,
then move the paper guide to the upright
position.
4. Set the paper release lever to the
single-sheet position.
5. Load single sheets as described in
“Loading Single Sheets” in the Reference
Guide.
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
Need help?
General