36
Top
Safety Instructions
Specications
Troubleshooting
Part Names and
Functions
Start Here
Cleaning
Initializing the
Settings
Purpose-based Index
Key Menu Index
Frame and Table Lists
Changing the Printer Settings +
Auto cut
Auto cut:
Sets whether or not to cut automatically.
Half cut:
When "Auto cut" is set to "On", the function "Half cut" for
precutting just the label part to make the backing paper
easy to peel o can be set.
MEMO
An extra margin might appear at the front of the label depending
on the kind of tape, and length and margin settings of the label.
The length of the extra margin varies depending on the setting
conditions.
Print density
Sets the print density.
Drop stop
This function is useful for axing consecutively printed
labels one at a time.
Select "On" to avoid a printed label from dropping. A printed
label stays at the tape eject slot.
When printing multiple copies, printing of the second or
later labels starts each time you remove a printed label.
This function is only available when the label length is
28mm or more, "Auto cut" is set to "On", and "Half cut" is set
to "O ".
Backlight
Sets the display backlight to On or O.
Language
You can select the language shown on the display from the
following:
Dansk, Deutsch, English, Español, Français, Italiano, Nederlands,
Norsk, Português-Br, Português-EU, Suomi, Svenska, Türkçe
inch:cm
The unit of length used to indicate the label size can be
switched between inch and cm.
MEMO
Version: To make sure the version number that has been installed in
the printer.
Procedure for setting
1. Press + .
2. Select the desired function with
/ and
press
.
3. Select the desired item with
/ and press .
To Next Page
Loading...
Need help?
General
