11
Top
Safety Instructions
Specications
Troubleshooting
Part Names and
Functions
Start Here
Cleaning
Initializing the
Settings
Purpose-based Index
Key Menu Index
Frame and Table Lists
Start Here
2. Installing a tape cartridge
CAUTION
• Make sure that the power is turned o.
• You cannot use tape other than LK-tape.
• Make sure the top cover is closed rmly.
• If you opened the top cover while a tape cartridge is
installed, check that the tape end is put into the tape
eject slot before beginning operation.
• Take care to keep the label for detecting the tape
cartridge and the sensor of the printer clean.
Otherwise, tape may no longer be detected correctly.
• Do not touch the sensor directly with your ngers.
Label for detection
Sensor
1. Rewind the ink ribbon.
Use a pen
or a pencil.
2. Open the top cover.
Top cover
3. Install a tape cartridge.
Put the tape end
into the tape eject
slot.
4. Close the top cover.
To Next Page
Loading...
Need help?
General
