3.
Turn the ribbon-tightening knob in the direction of the
a&w.
This removes any slack in the ribbon and makes it
easier to install. Next, hold the ribbon cartridge by its
handle and push it
fixmly
down into position; then
pnzss
on both ends of the cartridge to make sum the plastic
hooks fit into the slots.
4.
Use a pointed object, such as a ball point pen, to guide the
ribbon between the print head and ribbon guide. Turn the
ribbon-tightening knob to help feed the ribbon into
pla<~.
5.
Slide the print head from side to side to make sure it moves
smoothly. Also check that the ribbon is not twisted or
cre&.
1-6
Setting Up the Printer
To Next Page
Loading...
