Testing the Printer
Before connecting your printer to a computer, use the built-in
self-test function to see that the printer is working properly.
Before running the self test, you need to plug your printer's
power cord into an electrical outlet.
Plugging in the printer
1.
Make sure the printer is turned off.
2
Check the label on the back of the printer to make
sun2
the
voltage
nquired
by the printer matches that of your
electrical outlet.
m
ciaution:
If
the rated voltage and your outlet voltage do not match,
lTontadyourdtnlerfor&tarKx.Do~pluginthe
pouner~.
3.
If the power cord is not attached to the printer, connect it to
the AC inlet on
theprinteis
rear
par&
4.
Plug the power cord into a properly
gxxmded
electrical
outlet.
Running the self test
You can run the self test with either
ctM.nuous
paper or single
sheek.Also,youcanloadthepaperborthetestfromthetap,
mar, front, or bottom. The following steps describe how to run
the test on single-sheet paper,
loadd
fmm the top.
See
Chapter
2
for full details on paper handling.
Setting Up the Printer
1-9
To Next Page
Loading...
