Epson LQ-1070+ - Using Continuous Paper

Use the knob on the right side of the printer only to clear paper
jmnszahenthepn’ntaisoff.Othenctise,yyoumaydmnagethe
printer ur awe it to luse the top-oj$nm position.
If the platen turns but the printer doesn’t load the paper,
completely remove the paper and re-insert it more firmly.
To eject the paper, press the LOAD/EJECT button.
Note
7’he printer’s built-in stack in front of the paper gui& am hold up to
!SOsheetsofejectedpaper.
Using Continuous Paper
You can print on continuous paper from 101 mm (4 inches) to
254 mm (10 inches) wide on the LQ-570+ and from 101 mm (4
‘inches) to 406 mm (16 inches) wide on the LQ-1070+.
Tractor position and avai/abie paper paths
You can feed continuous paper from the rear, front, or bottom.
Your printer comes with the tractor installed in the
push-tractor position, for feeding paper from the rear. To feed
paper from the front
0rWto~installthetractorinthe
pull-tractor position. You can also install an optional pull
tradoranduseboththepushandpull~~~together.
Always move the paper-release lever to the position indicated
for the paper-feeding method you are using, as shown in the
table on page 2-8.
Make sure you align your paper supply with the paper loaded
in the tractor so the paper feeds smoothly into the printer.
Paper Handling 2-7