4.
Slide the left sprocket unit using the scale on the printer as a
guide. The
printer prints
to the right of the position
marked 0.
Push the sprocket lock lever back to lock the
sprocket unit in
place.
Then slide the right sprocket unit to
match the width of your paper, but do not lock it in
place.
Move the paper
support
so it is midway between the
spxxxket
unit&
5.
if you are
insert@
paper in thy front paper
slot,
remove the
front
cover and slide the edge guide
completely to the left.
6. h4akesureyourpaperhasaclean,straightedge.hsertthe
paperintothedesiredpapersld(rpar,frontor~)
untilitemergesbetweentheplatenindprinthead.
To Next Page
Loading...
