14 Paper Handling
❏ If you need to adjust the position of the paper after it is loaded, see
“Adjusting the top-of-form position” on page 20 and follow the
instructions.
❏ Do not pull out paper that is not ejected completely after pressing
the Load/Eject button. Doing so may cause paper jams or printer
malfunctions, also the top-of-form position setting may become
misadjusted.
After printing a sheet, the printer ejects it onto the paper guide
and the Paper Out and Pause lights come on. If you are printing
a multiple-page document, remove the printed sheet and insert a
new sheet into the paper guide. The printer automatically
advances the paper and resumes printing.
Note:
If the printer does not eject the printed sheet, press the Load/Eject
button.
Loading Special Paper
Multipart forms
Your printer can print on both single-sheet and continuous
multipart forms. It can use multipart forms with up to five parts
including the original.
c
Caution:
❏ Use only carbonless or carbon-backed multipart forms.
❏ When using multipart forms with a line of glue at the top of
the form, load the forms with the glued side first.
Before printing, set the paper-thickness lever to the appropriate
position for your multipart forms referring to the table in
“Adjusting the Paper-Thickness Lever” on page 3.
To Next Page
Loading...
