Control Panel 49
3
3
3
3
3
3
3
3
3
3
3
3
Lock-Out Mode
You can restrict the use of buttons on the control panel by using
the lock-out mode. In the basic setting, you can only use the Pause
and Load/Eject buttons, when the lock-out mode is on.
Turning on or off the lock-out mode
You can turn on or off the lock-out mode easily by using buttons
on the control panel.
Follow these steps to turn on the lock-out mode:
1. Make sure the printer is turned off.
2. Turn on the printer while holding down both the LF/FF and
Pause buttons more than five seconds. The printer beeps
twice, indicating that the lock-out mode has been turned on.
When the lock-out mode is on, the Pause and Paper Out lights
flash simultaneously when the locked buttons are pushed.
To turn off the lock-out mode, repeat steps 1 and 2. The printer
beeps once, indicating that the lock-out mode has been turned off.
See “Changing the lock-out mode setting” on page 49 for
instructions on how to change the functions to be locked.
Changing the lock-out mode setting
You can select the printer functions to be locked while the lock-out
mode is on according to your needs.
Note:
To print the language selection and panel lock-out mode instructions,
you need three sheets of A4 or letter size single-sheet paper or three pages
of continuous paper that is at least 279 mm (11 inches) long and 210
mm (8.3 inches) wide. See “Loading Continuous Paper” on page 5 and
“Loading Single Sheets” on page 12 for instructions on loading
continuous paper and single sheets.
To Next Page
Loading...
