Epson LQ-780N - SSL;TLS Communication with the Printer

Items Setting value and Description
IP Trap 1 to 4
Enable IP Trap X Select to enable IP traps 1, 2, 3, or 4.
Address Enter the IP address for the Trap Destination.
Community Name Enter a community name. You can enter up to 32 single-byte alphanumeric
characters, spaces, and the following symbols. ! $% & ’() * +,-.:; =? @ ^ _ ~
Port Number Set the port number of the host that receives the Trap in decimal numbers of 0 to
65535.
SNMPv3 Settings
Enable SNMPv3 SNMPv3 is enabled when the box is checked.
User Name Enter between 1 and 32 characters using 1 byte characters.
Authentication Settings
Algorithm Select an algorithm for an authentication for SNMPv3.
Password Enter the password for an authentication for SNMPv3. Enter between 8 and 32
characters in ASCII (0x20-0x7E). If you do not specify this, leave it blank.
Confirm Password Enter the password you configured for confirmation.
Encryption Settings
Algorithm Select an algorithm for an encryption for SNMPv3.
Password Enter the password for an encryption for SNMPv3.
Enter between 8 and 32 characters in ASCII (0x20-0x7E). If you do not specify this,
leave it blank.
Confirm Password Enter the password you configured for confirmation.
Context Name Enter within 32 characters or less in Unicode (UTF-8). If you do not specify this,
leave it blank. The number of characters that can be entered varies depending on
the language.
Related Information
& “Controlling Protocols” on page 28
& “Protocols you can Enable or Disable” on page 29
SSL/TLS Communication with the Printer
When the server certificate is set using SSL/TLS (Secure Sockets Layer/Transport Layer Security) communication
to the printer, you can encrypt the communication path between computers. Do this if you want to prevent remote
and unauthorized access.
Network Guide
Security Settings
32