Group Policy Setting Items
Items Settings and Explanation
Enable this Group Policy You can enable or disable a group policy.
Access Control Configure a control method for traffic of IP packets.
Permit Access Select this to permit configured IP packets to pass
through.
Refuse Access Select this to refuse configured IP packets to pass
through.
IPsec Select this to permit configured IPsec packets to pass
through.
Local Address(Printer) Select an IPv4 address or IPv6 address that matches your network environment. If
an IP address is assigned automatically, you can select Use auto-obtained IPv4
address.
Remote Address(Host) Enter a device’s IP address to control access. The IP address must be between 0
and 43 characters. If you do not enter an IP address, all addresses are controlled.
Note:
If an IP address is assigned automatically (e.g. assigned by DHCP), the connection
may be unavailable. Configure a static IP address.
Method of Choosing Port Select a method to specify ports.
Network Guide
Security Settings
41
To Next Page
Loading...
