Setting Up the Projector 37
Connecting a Component Video Source
If your video equipment has component video connectors (three
connectors labeled either Y/Cb/Cr or Y/Pb/Pr), you can purchase a
component-to-VGA video cable from Epson (see page 17) or an
electronics dealer.
1. Connect the component end of the cable (3 male RCA) to the Y/
Cb/Cr (or Y/Pb/Pr) connectors on your device.
2. Connect the other end of the cable (HD15 male) to the
Computer (Component Video) port on your projector using an
optional component-to-VGA video cable or adapter.
3. You may need to change the
Input Signal setting in the
projector’s Signal menu to
Auto (see page 70).
PowerLite S9
Computer (Component
Video) port
PowerLite 1220/PowerLite 1260
Computer (Component
Video) port
To Next Page
Loading...
