Connecting to a Projector on a Network and Projecting
15
2 Indicates the No. of an allocated projector. This No.
appears under the icon to indicate the No. of the
projector that you can control from the toolbar.
3 Indicates the status of the projector.
Stop
Stops projection while connected to the projector. A black
screen is projected while stopped.
Show
Releases Stop or Pause.
Pause
Pauses projected images while connecting to the projector.
Presentation Mode
Each time this is clicked, Presentation Mode switches
between enabled/disabled.
s "Projecting Only a PowerPoint Slide Show (Presentation
Mode)" p.23
Projector control
While the projector is connected to the network, the
projector's A/V Mute, Switch PC source and Switch video
source functions can be controlled from both the remote
control and the projector's control panel.
Click to display the following toolbar.
A/V Mute
Turns the video and audio on or off.
Switch PC source
Changes to images from the port where the
signal is being input.
Switch video source
Changes to images from the video input port.
To Next Page
Loading...
Need help?
General