Epson PowerLite 1940W User Manual

Power light Lamp light Temperature Status and solution
light
Red Off Red Projector has overheated and turned off. Leave it
turned off to cool down for five minutes.
• Make sure that the vents and air filter are not
clogged with dust or obstructed by nearby
objects.
• If operating the projector at high altitude, turn on
High Altitude Mode.
• If overheating continues, clean or replace the air
filter.
• If the problem persists, unplug the projector and
contact Epson for help.
Red Flashing red Off Lamp has a problem.
• Check to see if the lamp is burned out, broken,
or installed incorrectly. Reseat or replace the
lamp as necessary.
• If operating the projector at high altitude, turn on
High Altitude Mode.
• If the problem persists, unplug the projector and
contact Epson for help.
Light status Flashing Off Replace the lamp soon to avoid damage. Do not
varies orange continue using the projector.
Red Off Flashing red A fan or sensor has a problem. Turn the projector
off, unplug it, and contact Epson for help.
Red or flashing Flashing red Flashing red Internal projector error. Turn the projector off,
red unplug it, and contact Epson for help.
Note: If the lights display a pattern not listed in the table above, turn the projector off, unplug it, and
contact Epson for help.
Parent topic: Solving Problems
Related references
Projector Setup Settings - Extended Menu
158
Downloaded From projector-manual.com

Epson PowerLite 1940W Specifications

General

Number of colors	16.78 million colors
Native aspect ratio	16:10
Projection distance	- m
Projection technology	3LCD
Contrast ratio (dynamic)	3000:1
Contrast ratio (typical)	-
Screen size compatibility	29 - 280 \
Projector native resolution	WXGA (1280x800)
Keystone correction, horizontal	-30 - 30 °
Focus	Manual
Zoom capability	Yes
Focal length range	18.2 - 29.2 mm
Aperture range (F-F)	1.51 - 1.99
Lamp type	UHE
Lamp power	245 W
Light source type	Lamp
Service life of light source	2500 h
Service life of light source (economic mode)	4000 h
Full HD	No
Supported video modes	1080i, 1080p, 480i, 480p, 576i, 576p, 720p
Analog signal format system	NTSC, PAL, SECAM
RMS rated power	10 W
Number of built-in speakers	1
USB connector type	USB Type-A, USB Type-B
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity	0
Ethernet LAN data rates	10, 100 Mbit/s
Noise level	37 dB
Noise level (economic mode)	29 dB
Placement	Desktop, Ceiling
Product type	Standard throw projector
Product color	White
Cable lock slot type	Kensington
Power source	AC
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	3.8 W
Power consumption (typical)	311 W
Storage temperature (T-T)	5 - 35 °C

Weight and Dimensions

Weight	3900 g