5. Select the SNMP menu and press Enter (PowerLite 1945W/1955/1965).
6. Enter up to two IP addresses to receive SNMP notifications, using 0 to 255 for each address field.
Note: Do not use these addresses: 127.x.x.x or 224.0.0.0 through 255.255.255.255 (where x is a
number from 0 to 255).
7. If your network environment uses an AMX controller, turn on the AMX Device Discovery setting to
allow the projector to be detected (PowerLite 1940W/1950/1960).
8. If your network environment uses a Crestron RoomView controller, turn on the Crestron RoomView
setting to allow the projector to be detected (PowerLite 1940W/1950/1960).
9. If you are connecting to a network using Bonjour, turn on the Bonjour setting (PowerLite
1940W/1950/1960).
10. If you want this projector to receive broadcasted messages over the network, turn on the Message
Broadcasting setting. Administrators can broadcast messages over the network using the Message
Broadcasting plug-in for EasyMP Monitor (PowerLite 1940W/1950/1960) (Windows only).
11. When you finish selecting settings, select Complete or Setup Complete and follow the on-screen
instructions to save your settings and exit the menus.
Parent topic: Using the Projector on a Network
68
Downloaded From projector-manual.com
To Next Page
Loading...
