Epson PowerLite S4 User Manual

29
Saving a User's Logo
3 When "Choose this image as the User's Logo?" appears, select
"Yes".
4 The image to be recorded and a selection marquee box will be
displayed. Move the marquee box to select the part of the image
to use.
5 When "Select this image?" appears, select "Yes".
6 Select the zoom rate from the Zoom rate setting screen.
7 When "Save this image?" is displayed, select "Yes".
The image will then be saved. Once the image has been saved, the
message "Completed." will be displayed.
p
When you press the [Enter] button, the image will be displayed at its
original resolution. For example, if a video image or an image with a
resolution that is different from the projector’s native resolution is being
displayed, the image size will change.
Using the remote control
Using the control panel
p
User's logos can be saved at up to 400 × 300 dots in size.
p
• Saving the user's logo may take a few moments (about 15 seconds). Do
not use the projector or any other sources which are connected to the
projector while the user's logo is being saved, otherwise it may result in
errors in projector operation.
• Once a user's logo has been saved, the logo setting cannot be returned to
the factory default.

Epson PowerLite S4 Specifications

General

Number of colors	16.78 million colors
Projection distance	6 m
Vertical scan range	48 - 85 Hz
Horizontal scan range	15 - 92 kHz
Projection technology	LCD
Contrast ratio (typical)	500:1
Screen size compatibility	30 - 300 \
Projector native resolution	SVGA (800x600)
Keystone correction, vertical	-30 - 30 °
Lamp type	UHE
Lamp power	170 W
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	3000 h
Focus	Manual
Focal length range	16.6 mm
Interface	USB
Audio input	RCA x 2
Dimensions (WxDxH)	246 x 328 x 100 mm
Power requirements	100-240 V +/- 10%, 50/60 Hz AC
Connectivity technology	Wired
Noise level	36 dB
Dot clock scanning frequency	162 MHz
RMS rated power	1 W
Number of built-in speakers	1
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power consumption (standby)	5 W
Power consumption (typical)	250 W
Operating temperature (T-T)	5 - 35 °C

Weight and Dimensions

Weight	2600 g