Epson RX690 Series User Manual

22 Printing from a Memory Card
4. Select how far (in millimeters) to move
the print position.
5. Press OK, then try printing again.
Note:
This printer retains your settings even after it
has been turned off.
Printing a CD/DVD
Jacket
1. Load A4-size paper.
2. Press v Specialty Print.
3. Select Print on CD/DVD, then press OK.
4. Select CD Jacket Jewel Upper or CD
Jacket Jewel Index (& “Print settings
for Print on CD/DVD” on page 48), then
press OK.
5. Select a photo and set the number of
copies.
6. Press x Menu and change the settings
(& “Print settings for Print on
CD/DVD” on page 48). Then press OK.
7. Press x Start.
Replaying a Movie and
Printing a Shot
You can replay movies taken on a digital
camera and select a scene to print.
Note:
Because the number of pixels for a movie is
lower than for a photo you may not get the
expected printout quality. The number of pixels
depends on the digital camera model and the
setting.
1. Press v Specialty Print.
2. Select Play Movie and Print Photos,
then press OK.
3. Select Print 1 Frame or Print N Frames
as the Print Method. Then press OK.
4. Select the movie to play, then press OK.
Your printer plays the movie on the
memory card.
Note:
Depending on the movie data and the
transfer rate of your memory card or storage
device, your printer may not play the movie
smoothly.
5. Do one of the following:
Print 1 Frame:
When you see the scene that you want to
print, press OK.
Adjusting Description
1. Up
3. Down
Move the CD/DVD print
position up or down. You
can adjust it in 0.1 mm
steps from 0.0 to 2.0 mm.
2. Right
4. Left
Move the CD/DVD print
position left or right. You
can adjust it in 0.1 mm
steps from 0.0 to 2.0 mm.
Print 1
Frame
Prints one scene that you
select as one shot.
Print N
Frames
Divides the range of the
movie that you select into 12
frames and prints 12
thumbnail images on one
sheet.

Epson RX690 Series Specifications

General

Brand	Epson
Model	RX690 Series
Category	All in One Printer
Language	English