Epson SC-F6200 Series User Manual

o
Is the roll paper margin set to 15 mm or 35
mm?
If the value selected for Roll Paper Margin in the
Setup menu is wider than the margins selected in the
application, priority will be given to the value selected
for Roll Paper Margin. For example, if 15 mm is
selected for the left and right margins in the printer
menus and the document fills the page, the 15 mm at
the left and right sides of the page will not be printed.
U “Printable area” on page 36
Vertical ruled lines are misaligned.
o
Is the print head misaligned? (in bidirectional
printing)
With bidirectional printing, the print head prints while
moving left and right. If the print head is misaligned,
ruled lines may be misaligned accordingly. If vertical
ruled lines are misaligned with bidirectional printing,
perform Head Alignment.
U “Minimizing Print Misalignments (Head
Alignment)” on page 71
The printed surface is scuffed or
soiled.
o
Is the paper too thick or too thin?
Check that the paper specifications are compatible
with this printer. For information about the paper
types and appropriate settings for printing when
using RIP software, contact the manufacturer of the
RIP.
o
Is the paper creased or folded?
Do not use old paper or paper with folds in it. Always
use new paper.
o
Is the print head scuffing the printed surface?
If the surface of the paper is scuffed, select a Platen
Gap option between Wide and Wider in the Paper
menu.
U “Paper menu” on page 44
o
Is the print head scuffing the edge of the
paper?
Select Top35mm/Bottom15mm as the Roll Paper
Margin option in the Setup menu.
U “Setup menu” on page 48
o
Widen the bottom margin
Depending on the content of the print data, the
bottom edge may be scuffed when printing. In this
situation it is best to create your data with a bottom
margin of 150 mm.
o
Does the interior of the printer need
cleaning?
The rollers may need cleaning. Clean the rollers by
feeding and ejecting paper.
U “Cleaning the inside” on page 53
The reverse side of the printed paper
is soiled.
o
Select On for Paper Size Check in the menus.
Although under normal circumstances printing stops
if the print image is wider than the paper, the printer
may print outside the bounds of the paper when Off is
selected for Paper Size Check in the Setup menu. If it
prints beyond the edges of the paper, the inside of the
printer becomes dirty with ink.
Changed settings are reflected when the paper is
re-loaded.
U “Setup menu” on page 48
o
Is ink dry on the printed surface?
Depending on the printing density and paper type,
the ink may take a while to dry. Do not stack the paper
until the printed surface is dry.
U “Cleaning the inside” on page 53
Ink drops
SC-F6200 Series/SC-F6000 Series User's Guide
Problem Solver
78

Epson SC-F6200 Series Specifications

General

Brand	Epson
Model	SC-F6200 Series
Category	Printer
Language	English