11
Setting Up the SpectroProofer | 11
6. Attach the tile holder to the printer. Insert the two tabs on the bottom of
the holder into the slots on the printer. Then press the holder against the
printer until it clicks into place. The two tabs on the left side of the
holder should rest on top of the backing plate.
7. Install the SpectroProofer in the printer by sliding it onto the mounting
rails.
Caution:
Make sure the holder is
attached correctly,
otherwise the
spectrophotometer will
jam.
Warning:
The SpectroProofer is
heavy. Two people are
required to lift it.
To Next Page
Loading...
