Epson Spectroproofer - Connecting the Cables

12
12 | Setting Up the SpectroProofer
Connecting the Cables
The 44" SpectroProofer has a secondary USB port that can be used to
connect the optional Auto Take-up Reel (available for the Epson SureColor
P8000/P9000 only). The 24" SpectroProofer does not have this port.
1. Open the cover on the right side of the SpectroProofer.
2. Plug the USB-B end of the included SpectroProofer USB cable into the
square port marked with the printer symbol.
If you’ve also installed the optional Auto Take-up Reel, plug its
USB cable into the flat port marked with the take-up reel symbol
(44" model only).
Warning:
Make sure the printer and
the SpectroProofer are
unplugged from the AC
outlet before connecting
the SpectroProofer cables.
Auto Take-up Reel
SpectroProofer
Note:
To install the SpectroProofer,
you must disconnect the
Auto Take-up Reel from the
option port on the back of
the printer.