4
4 | Setting Up the SpectroProofer
Follow the steps in this section to install the SpectroProofer in your printer.
Before using the SpectroProofer for the first time, you must also initialize it
as described on page 16.
Unpacking and Assembly
Unpack the SpectroProofer and make sure you have all the parts shown
below:
Setting Up the
SpectroProofer
Warning:
The 44" SpectroProofer is
heavy. Two people are
required to lift it.
Caution:
Be sure to check the box
and packaging material
thoroughly for any missing
items; pieces may have
shifted during shipment.
SpectroProofer
main unit
Backing plates
(24" kit)
Backing plates
(44" kit)
Mounting rails, bolts, and hex wrench Spectrophotometer
(ILS30EP)
Calibration tile
and holder
Power cord
USB cable Cable hooks
OR
To Next Page
Loading...
