5
Setting Up the SpectroProofer | 5
1. Remove any tape and protective material from the outside surface of the
SpectroProofer.
2. Remove any tape from the paper presser, shown below. Raise the paper
presser and remove its packing material.
3. Remove any packing tape from the carriage.
Note:
The 44" model is shown.
These instructions also
apply to the 24" model.
Save the original box and
packing materials in case
you need to ship the
equipment.
Caution:
Check for packing material
all around and under the
paper presser.
To Next Page
Loading...
