8
8 | Setting Up the SpectroProofer
9. Connect the cables on the carriage to the spectrophotometer.
Installing the SpectroProofer
Before installing the SpectroProofer, make sure the printer has the latest
firmware installed. Follow the instructions for updating the firmware in your
Setup Guide.
1. Turn off the printer and unplug it from the AC outlet.
2. Remove the cover plate from the printer as shown.
Warning:
Make sure the
SpectroProofer and printer
are unplugged from the AC
outlet before connecting
the spectrophotometer
cables. Be careful not to
dislodge the
spectrophotometer when
connecting the cables.
To Next Page
Loading...
