Assigning a Name to the Printer
After you install the AT-StylusColor driver, you need to assign
a name to the printer using the EPSON Namer Utility. Use the
following procedure to assign a name.
Note:
AppleTalk must be active.
1. Double-click the EPSON Namer icon. The EPSON Namer
Utility will be located on your hard drive if you installed it.
2. Click the AT-StylusColor icon in the Device Types window.
3. If there are multiple AppleTalk zones at your site, select the
zone in which the printer is located.
4. Under Select Printer, click the printer you want to rename.
5. Under New Name, enter a name for your printer. You
should assign a name that clearly distinguishes your
printer from others on the network.
6. Click Rename. The new name for your printer is listed
under Select Printer.
7. Click Done to exit EPSON Namer.
Using the Chooser to Select the Printer
After you install the printer driver, follow the steps below to
select the printer before you begin printing. You need to choose
the printer only the first time you use it or whenever you want
to use another printer. (Your Macintosh always prints using the
last printer selected.)
2-4
Installing and Using the Printer Driver
To Next Page
Loading...
