Chapter 3
Using the Printer Driver Utilities
This chapter explains managing print jobs that you send to the
printer with the Epson Monitor2 Utility. It also tells you how to
calibrate the printer using the Bi-D Calibration Utility if vertical
lines in your printed output become misaligned.
If you selected the Network Driver Package option when you
installed the driver, both of these utilities were copied to your
hard disk. If you did not select the Network Driver Package
option, you can install these utilities from the Macintosh
printer driver diskette using the Installer program. See
page 2-1 for instructions.
Managing Print Jobs on the Macintosh
You can use the Epson Monitor2 Utility to check on the status
of print jobs that are queued for printing. The utility also
allows you to cancel any print job in the queue.
You can access the Epson Monitor2 utility by double-clicking
the Epson Monitor2 icon. If you would like the utility to
appear each time you print, follow the steps below:
1. Before using Epson Monitor2, you must first select
background printing using the Chooser (if you have not
done so already). See “Using the Chooser to Select the
Printer” in Chapter 2 for instructions.
2. Double-click the Epson Monitor2 icon. (It was automatically
installed in the Extensions folder if you installed it.)
3. In the menu bar, click File.
4. Select Preferences. The Show Epson Monitor When Printing
option appears.
Using the Printer Driver Utilities
3-1
To Next Page
Loading...
