Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
Revision G
DISASSEMBLY/ASSEMBLY Disassembly Procedures 137
Confidential
4. Attach the SEAL JOINT,H on the ink supply holes of the Printhead.
Figure 4-62. Assembling the Printhead (2)
5. Insert the tip of the Ink Supply Tube screwing tool to the screw holes (x2) of the
Ink Supply Tube Assy.
Figure 4-63. Assembling the Printhead (3)
6. Into the screw holes of the Printhead, align and slowly insert the tip of the Ink
Supply Tube screwing tool inserted in the Ink Supply Tube Assy.
7. Insert the thickness gauge from the hole on the side of the Ink Supply Tube
screwing tool, and remove the tool gently while holding the Ink Supply Tube
Assy.
Figure 4-64. Assembling the Printhead (4)
Ink supply holes SEAL JOINT,H
Ink Supply Tube screwing tool
Ink Supply Tube Assy
Screw hole
If the joint of the Printhead and the Ink Supply Tube Assy is not
disconnected, simply tighten the screw shown in
Fig. 4-68 without
using the jig.
Insert from 0 digit side
Ink Supply Tube screwing tool
Thickness gauge
To Next Page
Loading...
