Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
Revision G
DISASSEMBLY/ASSEMBLY Routing FFC/cables 199
Confidential
CARD SLOT ASSY
Note * :See Fig. 4-196 for the connector positions on the Main Board.
Figure 4-200. Card Slot Assy (1)
Figure 4-201. Card Slot Assy (2)
No. FFC/cable name CN No.
*
Remarks
1 I/F FFC (Infra-red) CN32
Mounted only in Japanese
models.
2 SUB FFC CN7 ---
3 STG FFC CN31 Ferrite core x1
STG FFC:
Fold this along the line mark on
the Card Slot Assy, and secure
it with double-sided tape.
Front side of the
Card Slot Assy
Double-sided tape
Fold line
Fold
Line mark
Bottom of the
Card Slot Assy
SUB FFC
I/F FFC
(Mounted only in Japanese models.)
Ferrite core
Double-sided tape
Fold line
I/F FFC (Mounted only in
Japanese models.)
SUB FFC:
Route this between the ferrite core and Base Frame, and
secure it to the Main Board Unit with double-sided tape
STG FFC:
Put STG FFC through the ferrite core
and attach it to the Base Frame.
To Next Page
Loading...
