WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision A
Disassembly And Assembly Disassembling the Printer Mechanism 108
Confidential
6. Remove the two C.B.S. M3 x 4 screws that secure the Ink System Guide Plate, and
remove it.
Figure 4-110. Removing the Ink System Guide Plate
7. Grip both ends of the Ink Tube fasteners with your fingers, slide them in the
direction of the arrows, and pull out the Ink Tube from the Joint Tube.
8. Squeeze and hold both ends of the fastener attached on Ink Tube and slide it in the
direction of the arrow, then pull out the Ink Tube from the Joint Tube.
Figure 4-112. Removing the Ink Tube
9. Remove the two C.B.S. M3 x 6 screws that secure the Ink System Unit.
Figure 4-113. Screws that Secure the Ink System Unit
Align the notch on the Ink System Guide Plate with the notch
on the Main Frame.
Referring to Figure 4-110 and Figure 4-111, attach a piece of
acetate tape.
Figure 4-111. Reinstalling the Ink System Guide Plate
Tighten the screws in the order shown in Figure 4-110
1
2
10) C.B.S. M3x4
(8±1 kgf.cm)
Ink System Guide
Plate
Acetate tape
Tighten the screws in the order shown in Figure 4-113
Ink Tube
Fastener
Joint Tube
2) C.B.S. M3x6
(8±1 kgf.cm)
高速行式打印机 http://www.lineprinter.com.cn/
_______________________________________________________________________________________
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/ 打印机驱动下载 http://www.printerwhy.com/
To Next Page
Loading...
