Epson Stylus Photo R340 - Page 87

EPSON Stylus Photo R340/350 Revision A
Disassembly and Assembly Disassembly 87
 Reinstalling the CD-R Guide Assy.
z Install the CD-R Guide Assy. first from its left side, and
right side, and then the center portion.
z Move the coiled part of the Right EJ Grounding Spring in
the direction of the arrow, and hitch the shorter leg of the
spring to the tab of the CD-R Guide Assy. while holding the
other longer leg with your fingers. Bring the longer leg to
contact with the surface of the EJ Roller Assy.
Figure 2-84. Reattaching the Right EJ Grounding Spring
z Make sure that the Left and Right CD-R Links are
correctly installed.
z Make sure that the connector cable of the Tray/CD-R
Sensor does not interfere with the Right CD-R Link.
z Make sure that the EJ Frame Assy. moves smoothly
together with the CD-R Guide Assy.
 Reinstalling the Main Frame Support Plate
z Tighten the screws in the order shown in Figure 2-79.
Before reassembling
the Printer Mechanism
Right EJ Grounding Spring
Shorter Leg
Longer Leg
After reassembling the
Printer Mechanism
EJ Roller
Assy.