Epson Stylus Photo R340 - Page 86

EPSON Stylus Photo R340/350 Revision A
Disassembly and Assembly Disassembly 86
 Reinstalling the Tray Sensor Lever
z Insert the Torsion Spring 2.8 onto the shaft of the Upper
CD-R Guide.
z Pull the L-shaped leg of the Torsion Spring 2.8 with
tweezers in the direction shown in the figure below.
z Set the positioning hole ( ) of the Tray Sensor Lever onto
the shaft of the Upper CD-R Guide, and hitch the L-shaped
leg of the Torsion Spring 2.8 to the position shown below.
Figure 2-82. Reinstalling the Tray Sensor Lever
Torsion Spring 2.8
Tray Sensor Lever
Hitch the
Spring
Leg here
 Reinstalling the CD-R Sensor Lever
z Insert the Torsion Spring 4.26 onto the shaft of the Upper
CD-R Guide.
z Set the positioning hole ( ) of the CD-R Sensor Lever onto
the shaft of the Upper CD-R Guide, and hitch the L-shaped
leg of the Torsion Spring 4.26 to the position shown below.
Figure 2-83. Reinstalling the CD-R Sensor Lever
 Reinstalling the Lower CD-R Guide
z Tighten the screws in the order shown in Figure 2-80.
 Reinstalling the Upper CD-R Guide
z Make sure that the two tabs of the Stacker Lock are
properly secured with a tension of the Compression Spring
5.1. See Figure 2-80.
z After reinstalling the Lower CD-R Guide, make sure there
is no gap between the Lower and Upper CDR Guides.
Torsion Spring 4.26
CD-R Sensor
Lever
Hitch the Spring
Leg here